ADAC3 Click example. More...

#include "board.h"
#include "log.h"
#include "adac3.h"

Functions
void	application_init (void)

void	application_task (void)

int	main (void)

Detailed Description

ADAC3 Click example.

Description

This example demonstrates the use of ADAC 3 click board by setting the DAC output and reading the ADC results from 2 single-ended channels (AIN0, AIN1) and from a differential channel (AIN2+, AIN3-).

The demo application is composed of two sections :

Application Init

Initializes the driver and performs the click default configuration which enables DAC output, sets the analog input mode to single-ended (AIN0, AIN1) and differential (AIN2+, AIN3-), and enables the auto increment mode.

Application Task

Sets the DAC output increasing the value by 1 after each iteration, and reads the ADC results from 2 single-ended and 1 differential channels, and displays the results on the USB UART every 100ms approximately.

Note: Inputs should be connected to GND when not in use.

Author: Stefan Filipovic

Function Documentation

◆ application_init()

void application_init ( void )

< Logger config object.

< Click config object.

Logger initialization. Default baud rate: 115200 Default log level: LOG_LEVEL_DEBUG

Note: If USB_UART_RX and USB_UART_TX are defined as HAL_PIN_NC, you will need to define them manually for log to work. See LOG_MAP_USB_UART macro definition for detailed explanation.

◆ application_task()

void application_task ( void )

◆ main()

int main ( void )

Functions