C10Dof Click example. More...

#include "board.h"
#include "log.h"
#include "c10dof.h"

Functions
void	application_init (void)

void	application_task (void)

int	main (void)

Detailed Description

C10Dof Click example.

Description

This example shows temperature,humidity,pressure, and values such as accel, gyro and magnetometer coordinates for X,Y and Z axis.

The demo application is composed of two sections :

Application Init

Initialization driver enables - I2C, set default configuration of BMP180 and BNO055 chip, also display logs.

Application Task

This is a example which demonstrates the use of 10DOF Click board. Measured temperature, humidity pressure data from the BME180 chip sensor and accel, gyro and magnetometar coordinates values for X-axis, Y-axis and Z-axis. Display temperature data to degrees Celsius [ C ], pressure data [ mbar ], rate in dps, accel in mg and magnetometar in �T. Results are being sent to the Usart Terminal where you can track their changes. All data logs write on usb uart changes for every 3 sec.

NOTE

Additional pull-up on I2C lines might be required.

Author: MikroE Team

Function Documentation

◆ application_init()

void application_init ( void )

Logger initialization. Default baud rate: 115200 Default log level: LOG_LEVEL_DEBUG

Note: If USB_UART_RX and USB_UART_TX are defined as HAL_PIN_NC, you will need to define them manually for log to work. See LOG_MAP_USB_UART macro definition for detailed explanation.

◆ application_task()

void application_task ( void )

◆ main()

int main ( void )

Functions