DcMotor8 Click example. More...

#include "board.h"
#include "log.h"
#include "dcmotor8.h"

Functions
void	application_init (void)

void	application_task (void)

int	main (void)

Detailed Description

DcMotor8 Click example.

Description

This click can drive simple DC motors with brushes, providing them with a significant amount of current and voltage up to 40V. The click has one control input, that uses the PWM signal from the host MCU. It uses the half-bridge topology to regulate the speed of the motor rotation, employs advanced dead-time circuitry that monitors the output stage, providing maximum switching efficiency and features an advanced technique to avoid shoot-through currents.

The demo application is composed of two sections :

Application Init

Initializes the driver and enables the click board.

Application Task

This is an example that demonstrates the use of DC Motor 8 click board by increasing and decreasing the motor speed. DC Motor 8 Click communicates with the register via the PWM interface. Results are being sent to the Usart Terminal where you can track their changes.

Author: Nikola Peric

Function Documentation

◆ application_init()

void application_init ( void )

Logger initialization. Default baud rate: 115200 Default log level: LOG_LEVEL_DEBUG

Note: If USB_UART_RX and USB_UART_TX are defined as HAL_PIN_NC, you will need to define them manually for log to work. See LOG_MAP_USB_UART macro definition for detailed explanation.

◆ application_task()

void application_task ( void )

◆ main()

int main ( void )

Functions