ADAC 2 Click example. More...

#include "board.h"
#include "log.h"
#include "adac2.h"

Functions
void	application_init (void)

void	application_task (void)

int	main (void)

Detailed Description

ADAC 2 Click example.

Description

This example demonstrates the use of ADAC 2 click board by setting the DAC output (CIO) and reading the ADC results from a single-ended channel (AI4) and from a differential channel (AI5+, AI6-) as well as toggling all GPIO pins.

The demo application is composed of two sections :

Application Init

Initializes the driver and performs the click default configuration which enables DAC voltage output, sets the analog input mode to single-ended for AI4 and differential (AI5+, AI6-), and enables all GPIOs as output.

Application Task

Reads the ADC results from a single-ended (AI4) and a differential (AI5+, AI6-) channels, then sets the raw DAC output increasing the value by 10000 after each iteration, and toggles all GPIO pins. The results will be displayed on the USB UART approximately once per second.

Author: Stefan Filipovic

Function Documentation

◆ application_init()

void application_init ( void )

< Logger config object.

< Click config object.

Logger initialization. Default baud rate: 115200 Default log level: LOG_LEVEL_DEBUG

Note: If USB_UART_RX and USB_UART_TX are defined as HAL_PIN_NC, you will need to define them manually for log to work. See LOG_MAP_USB_UART macro definition for detailed explanation.

◆ application_task()

void application_task ( void )

◆ main()

int main ( void )

Functions