Pressure14 Click example. More...

#include "board.h"
#include "log.h"
#include "pressure14.h"

Functions
void	application_init (void)

void	application_task (void)

int	main (void)

Detailed Description

Pressure14 Click example.

Description

This examples used ABP2 Series are piezoresistive silicon pressure sensors offering a digital output for reading pressure over the specified full scale pressure span and temperature range. They are calibrated and temperature compensated for sensor offset, sensitivity, temperature effects and accuracy errors (which include non-linearity, repeatability and hysteresis) using an on-board Application Specific Integrated Circuit (ASIC).

The demo application is composed of two sections :

Application Init

Initialization driver enables I2C.

Application Task

The output measurement command is sent first forcing the ABP2 pressure sensor to exit standby mode and enter operating mode. The device busy state is evaluated via the end-of-conversion pin ( INT ) following the pressure and temperature data acquisition and calculation. The results are being sent to the Usart Terminaland repeats every 5 seconds.

Author: Jelena Milosavljevic

Function Documentation

◆ application_init()

void application_init ( void )

< Logger config object.

< Click config object.

Logger initialization. Default baud rate: 115200 Default log level: LOG_LEVEL_DEBUG

Note: If USB_UART_RX and USB_UART_TX are defined as HAL_PIN_NC, you will need to define them manually for log to work. See LOG_MAP_USB_UART macro definition for detailed explanation.

◆ application_task()

void application_task ( void )

◆ main()

int main ( void )

Functions