Temp-Log 2 Click example. More...

#include "board.h"
#include "log.h"
#include "templog2.h"

Functions
void	application_init (void)

void	application_task (void)

int	main (void)

Detailed Description

Temp-Log 2 Click example.

Description

This example demonstrates the use of the Temp-Log 2 Click board.

The demo application is composed of two sections :

Application Init

Initializes peripherals and pins. Initializes I2C driver and performs device configuration. Sets total active conversion time to 250 ms and 8 average samples. Also sets Shutdown Mode as default mode, and after device reset puts device in Continuous Conversion Mode. High limit status will be set when temperature cross over the determined high limit temperature value. Low limit status will be set when temperature falls below the determined low limit temperature value.

Application Task

Reads temperature value calculated to Celsius degrees.

Author: Nemanja Medakovic

Function Documentation

◆ application_init()

void application_init ( void )

Logger initialization. Default baud rate: 115200 Default log level: LOG_LEVEL_DEBUG

Note: If USB_UART_RX and USB_UART_TX are defined as HAL_PIN_NC, you will need to define them manually for log to work. See LOG_MAP_USB_UART macro definition for detailed explanation.

◆ application_task()

void application_task ( void )

◆ main()

int main ( void )

Functions