Ultrasonic 5 Click example. More...

#include "board.h"
#include "log.h"
#include "ultrasonic5.h"

Functions
void	application_init (void)

void	application_task (void)

int	main (void)

Detailed Description

Ultrasonic 5 Click example.

Description

This example demonstrates the use of Ultrasonic 5 click board by reading the measurements from the connected ultrasonic sensor and displaying it on a Serial Plot.

The demo application is composed of two sections :

Application Init

Initializes the driver and performs the click default configuration.

Application Task

Performs a burst generation which starts the measurement and then reads the next 200 ADC samples and displays the results on the USB UART (SerialPlot).

Note: In order to get valid measuremets a proper ultrasonic sensor must be connected to OUTA and OUTB. We have used an UTR-1440K-TT-R sensor for the test. We recommend using the SerialPlot tool for data visualizing. Refer to the datasheet "Application Curves" section in order to check and compare the results from the plotter.

Author: Stefan Filipovic

Function Documentation

◆ application_init()

void application_init ( void )

< Logger config object.

< Click config object.

Logger initialization. Default baud rate: 115200 Default log level: LOG_LEVEL_DEBUG

Note: If USB_UART_RX and USB_UART_TX are defined as HAL_PIN_NC, you will need to define them manually for log to work. See LOG_MAP_USB_UART macro definition for detailed explanation.

◆ application_task()

void application_task ( void )

◆ main()

int main ( void )

Functions